Fine-tune Oat Seeding Rate for Spring Planting

With spring’s arrival, it is time to plant oats, spring wheat and barley. Farmers typically plant two to three bushels of small grains per acre, but there is a better way to ensure plant populations to optimize small grain yields.

New research from Iowa State University shows that farmers should use the same level of management for small grains as they do when managing corn or soybeans. By using seed counts per acre when planting, instead of a “by the bushel” rate calculation, farmers can receive both yield and financial benefits.

For maximum oat yields, harvest plant populations should be 1.0 to 1.3 million plants per acre, or approximately 22 to 29 plants per square foot, according to recent research by Mary Wiedenhoeft, professor of agronomy at Iowa State University, and David Weisberger, graduate student in agronomy. The study is supported by the Iowa Organic Association.

Several factors affect the final plant stand at oat harvest: The desired final plant stand, number of oat seeds per pound, germination rate in the seed lot and expected stand loss from irregular seeding depth or early plant death.

“Calculating seeding rates in terms of seeds per acre rather than bushels will improve planting accuracy and help optimize yields,” said Weisberger. “Oat bushels are standardized at 32 pounds per bushel but there is a range of actual test weights that affect the accuracy of planting by the bushel. Additionally, seed quantities vary from 12,000 to 17,000 seeds per pound depending on the oat cultivar and growing conditions under which the seed was produced.”

Small grain seed counts per pound are not commonly listed on seed bags, but farmers can request that information seed dealers can provide that information if they have an automated seed counter. If not, farmers can determine seed counts themselves by weighing an ounce of seed on a digital scale, counting the seeds per ounce, and multiplying that by 16 to calculate seeds per pound.

When calculating the seed drop rate, it is important to account for the germination rate of the seed lot, typically 92-95 percent, and for typical stand establishment losses of 10-20 percent due to early irregular seeding depths and early season plant mortality. This will increase the amount of seed needed at planting. A recommended formula for calculating oat seeding rate is:

  1. Determine desired final stand per acre and divide by: (1-expected stand establishment loss).
  2. Calculate seeds per pound and multiply by the germination rate of the seed lot.
  3. Divide 1 by 2 for the final seeding rate.

The Department of Agriculture in Alberta, Canada, has developed an online calculator to determine seeding rates for oats and other small grains. Note that the rates in Canada are calculated using grams, not ounces. This can be converted by using 28.35 grams per ounce.

If oat or other small grain planting is delayed, fewer tillers (plant stems that produce seed heads from an individual seedling) will form and reduced grain yields will result. The University of Minnesota advises increasing seeding rates by 1 percent for each day after the optimum spring small grain seeding date to compensate for less tillering.

Research is ongoing at Iowa State University to determine the optimum oat seeding rates for different seeding dates in Iowa.

Small grains acres are increasing on organic farms and by farmers growing cover crop seed, according to Margaret Smith, a specialist with the ISU Extension and Outreach Value Added Agriculture program. Small grain growers can benefit by increasing management practices for these crops.

Recent News

The 2020 Outlook for U.S. Agriculture From USDA’s Chief Economist

Speaking on Thursday at USDA’s Agricultural Outlook Forum in Arlington, Virginia, USDA Chief Economist Robert C. Johansson provided a broad outlook for U.S. agriculture.  Today’s update provides an overview of key aspects of Dr. Johansson’s presentation. In his speech Thursday (transcript / slides), Dr. Johansson noted that, “Despite mixed signals heading into 2020, there has been important progress on the trade policy […]

Corn Prices-Farmer Holding and the Coronavirus

Old crop corn basis and futures spreads continue to signal a smaller crop scenario than the price levels in the futures market suggest.  Futures price levels reflect the uncertainty associated with the coronavirus and the potential weaker growth its continuation promises.  Producer grain holding remains the popular explanation for a strong basis and small futures […]

Highlights from USDA Trade and Commodity Outlook Reports

Following this month’s release of the USDA’s Long-Term Projections, on Thursday, the Department released its quarterly Outlook for U.S. Agricultural Trade.  This update provided an overview of agricultural trade based on the 2020 fiscal year, which began in October, months before the U.S. and China signed the Phase-One trade agreement.  Recall that Phase One farm purchase commitments are based […]

Your browser is out-of-date!

Update your browser to view this website correctly. Update my browser now